Factory automation show heads to Quebec

April 1, 2004
The Montreal Manufacturing Technology Show runs May 17-19 at Place Bonaventure in Montreal. Part of the MMTS is the National Factory Automation Show, which covers plant floor automation and control systems such as automated assembly; robotics; CAD/CAM/CIM

The Montreal Manufacturing Technology Show runs May 17-19 at Place Bonaventure in Montreal. Part of the MMTS is the National Factory Automation Show, which covers plant floor automation and control systems such as automated assembly; robotics; CAD/CAM/CIM; instrumentation and controls; motion control; industrial workstations; system integrators; electronic and electrical equipment; and sensors and vision systems. A total of 8,543 visitors from 3,454 companies attended the last event.

To find out more about NFAS, check out www.mmts.ca.

Continue Reading

Motor leakage variations

Oct. 18, 2006
affect low-speed performance

The Impacts of Electrification on Fluid Power Systems

May 15, 2023
Electrification presents challenges as well as opportunities to re-evaluate and improve upon the design of hydraulics and pneumatics.

Sponsored Recommendations

7 Key Considerations for Selecting a Medical Pump

Feb. 6, 2024
Newcomers to medical device design may think pressure and flow rate are sufficient parameters whenselecting a pump. While this may be true in some industrial applications, medical...

How Variable Volume Pumps Work

Feb. 6, 2024
Variable volume pumps, also known as precision dispense pumps, are a positive displacement pump that operates by retracting a piston to aspirate a fluid and then extending the...

What is a Check Valve and How Does it Work?

Feb. 6, 2024
Acheck valve, a non-return or one-way valve, is a mechanical device that allows a gas or liquid to flow freely in one direction while preventing reverse flow in the opposite ...

The Difference Between Calibrated Orifices and Holes

Feb. 6, 2024
Engineers tasked with managing fluid flow talk about both holes and calibrated orifices, but they are two distinct entities. A hole can be any opening, but a calibrated orifice...