Hydraulicspneumatics 2195 Standardization
Hydraulicspneumatics 2195 Standardization
Hydraulicspneumatics 2195 Standardization
Hydraulicspneumatics 2195 Standardization
Hydraulicspneumatics 2195 Standardization

What makes standardization so difficult?

July 27, 2010
As we become increasingly global in our everyday dealings, differences in units of measure become more obvious. The push for U. S. adoption of the metric system has been going on for generations. It will probably never happen — at least officially — because no administration will want to have to force multiple industries to bear the tremendous cost of converting to metric measurements. In fact, I think it would be more likely for an administration to introduce legislation declaring English as the official language of the U.S.

As we become increasingly global in our everyday dealings, differences in units of measure become more obvious. The push for U. S. adoption of the metric system has been going on for generations. It will probably never happen — at least officially — because no administration will want to have to force multiple industries to bear the tremendous cost of converting to metric measurements. In fact, I think it would be more likely for an administration to introduce legislation declaring English as the official language of the U.S. — a move that would actually save money by eliminating the costs associated with producing government documents in two languages. Most industries would also benefit from such a move.

I was recently reminded of all this while traveling through New York and Massachusetts. In most states, mile markers on interstate highway exits are numbered according to the preceding mile marker, so it's easy to tell how far it is between exits using simple arithmetic. However, exit numbers on interstate highways in New York and Massachusetts do not coincide with mileage markers — they are simply numbered sequentially, with no regard for mile markers. So if you've just passed exit 15, you have no way of determining how far it is to exit 16 — it could be 5 miles or 55 miles.

Standardizing on exit numbers should be easy and relatively inexpensive — at least compared to switching to the metric system. So if it is so difficult to standardize on exit numbers, it must be wishful thinking to expect governmental endorsement of the metric system in our lifetime.

If we ever do adopt the metric system, I'm sure it will result from the accumulated voluntary actions of individual industries — much like the fluid power industry's adoption of so many useful standards. If so, it would happen the same way you'd eat an elephant — one bite at a time.

About the Author

Alan Hitchcox Blog | Editor in Chief

Alan joined Hydraulics & Pneumatics in 1987 with experience as a technical magazine editor and in industrial sales. He graduated with a BS in engineering technology from Franklin University and has also worked as a mechanic and service coordinator. He has taken technical courses in fluid power and electronic and digital control at the Milwaukee School of Engineering and the University of Wisconsin and has served on numerous industry committees.

Continue Reading

BOOK 2, CHAPTER 12: Fluid Motor Circuits

March 18, 2009
Table of Contents

Motor leakage variations

Oct. 18, 2006
affect low-speed performance

Sponsored Recommendations

7 Key Considerations for Selecting a Medical Pump

Feb. 6, 2024
Newcomers to medical device design may think pressure and flow rate are sufficient parameters whenselecting a pump. While this may be true in some industrial applications, medical...

How Variable Volume Pumps Work

Feb. 6, 2024
Variable volume pumps, also known as precision dispense pumps, are a positive displacement pump that operates by retracting a piston to aspirate a fluid and then extending the...

What is a Check Valve and How Does it Work?

Feb. 6, 2024
Acheck valve, a non-return or one-way valve, is a mechanical device that allows a gas or liquid to flow freely in one direction while preventing reverse flow in the opposite ...

The Difference Between Calibrated Orifices and Holes

Feb. 6, 2024
Engineers tasked with managing fluid flow talk about both holes and calibrated orifices, but they are two distinct entities. A hole can be any opening, but a calibrated orifice...